FAQ / + Get message saying “Manipulation is currently being run” just after selecting to Begin Replacement

AFTER PREMATURE TERMINATION: The MAN product has been developed to explicitly prevent the same module from being run more than once at a time. By nature of this process and the possibilities of unforeseen failures, both hardware and software related, the module being run before the failure is unable to be rerun after the problems have been resolved. As an interim solution, we have a “RESET” utility program that may be used to reset that module. Using File\Run a program (Control+R) and enter MANRES before selecting OK to run. Choose the relevant module as per figure 1 below and select the Reset button.

Posted in: Manipulation, Technical